Diminished Respirative Growth and Enhanced Assimilative Sugar Uptake Result in Higher Specific Fermentation Rates by the MutantPichia stipitis FPL-061

A mutant strain ofPichia stipitis, FPL-061, was obtained by selecting for growth on L-xylose in the presence of respiratory inhibitors. The specific fermentation rate of FPL-061, was higher than that of the parent,Pichia stipitis CBS 6054, because of its lower cell yield and growth rate and higher specific substrate uptake rate. With a mixture of glucose and xylose, the mutant strain FPL-061 produced 29.4 g ethanol/L with a yield of 0.42 g ethanol/g sugar consumed. By comparison, CBS 6054 produced 25.7 g ethanol/L with a yield of 0.35 gJg. The fermentation was most efficient at an aeration rate of 9.2 mmoles O₂ L^-1 h^-1. At high aeration rates (22 mmoles O₂ L^-1 h^-1), the mutant cell yield was less than that of the parent. At low aeration rates, (1.1 to 2.5 O₂ L^-1 h^-1), cell yields were similar, the ethanol formation rates were low, and xylitol accumulation was observed in both the strains. Both strains respired the ethanol once sugar was exhausted. We infer from the results that the mutant, P.stipitis FPL-061, diverts a larger fraction of its metabolic energy from cell growth into ethanol production.     

A high-frequency and high-field EPR study of new azide and fluoride mononuclear Mn(III) complexes

The isolation, structural characterization and electronic properties of three new six-coordinated Mn(III) complexes, [Mn(bpea)(F)(3)] (1), [Mn(bpea)(N(3))(3)] (2), and [Mn(terpy)(F)(3)] (3) are reported (bpea = N,N-bis(2-pyridylmethyl)-ethylamine; terpy = 2,2':6',2' '-terpyridine). As for [Mn(terpy)(N(3))(3)] (4) (previously described by Limburg J.; Vrettos J. S.; Crabtree R. H.; Brudvig G. W.; de Paula J. C.; Hassan A.; Barra A-L.; Duboc-Toia C.; Collomb M-N. Inorg. Chem. 2001, 40, 1698), all these complexes exhibit a Jahn-Teller distortion of the octahedron characteristic of high-spin Mn(III) (S = 2). The analysis of the crystallographic data shows an elongation along the tetragonal axis of the octahedron for complexes 1 and 3, while complex 2 presents an unexpected compression. The electronic properties were investigated using a high-field and high-frequency EPR study performed between 5 and 15 K (190-575 GHz). The spin Hamiltonian parameters determined in solid state are in agreement with the geometry of the complexes observed in the crystal structures. A negative D value found for 1 and 3 is related to the elongated tetragonal distortion, whereas the positive D value determined for 2 is in accordance with a compressed octahedron. The high E/D values, in the range of 0.103 to 0.230 for all complexes, are correlated with the highly distorted geometry present around the Mn(III) ion. HF-EPR experiments were also performed on complex 1 in solution and show that the D value is the only spin Hamiltonian parameter which is slightly modified compared to the solid state (D = -3.67 cm(-1) in solid state; D = -3.95 cm(-1) in solution).     

Complexation of palladium cyanide with imidazolidine-2-thione and its derivatives

Summary Pd(CN)₂ reacts with imidazolidine-2-thione (Imt), 1,3-diazinane-2-thione(Diaz), 1,3-diazipnane-2-thione (Diap) and their derivatives to yield complexes of stoichiometry [PdL₂(CN)₂] or [PdL(CN)₂] (L = Imt, Diaz or Diap and L = Imt having N-Me, Et or Pr substituents), which were characterized by elemental analysis, i.r., ¹H and ¹³C n.m.r. spectroscopy. Both mono- and bis ligand complexes are thought to be square planar with the monoligand binding to metal via sulphur (bridging) and the bis ligand via the monodentate thione group. The ¹³C enriched Pd(¹³CN)₂ complex was prepared and the ¹³C n.m.r. recorded. The C-2 resonance of ¹³C n.m.r. of Imt, Diaz or Diap complexes of the copper(I), silver(I), gold(I) and palladium(II) were compared.     

A New Neutral Carrier for Silver Ions Based on a Bis(Thiothiazole) Derivative and its Evaluation in Membrane Electrodes

Membrane electrodes based on 2,2-dithiobis(benzothiazole), DTBBT, as a neutral carrier for silver ions are described. Silver-selective membrane electrodes formulated with 2wt% DTBBT ionophore and 50mol% TFPB in an FPNPE plasticized poly (vinyl chloride) exhibited near-Nernstian responses towards silver ions (60.3±0.5mVdecade^–1) over a wide silver ion activity range of 0.83µM to 94mM. Increasing the amount of anionic sites, TFPB, to 100 or 150mol% (relative to the DTBBT weight) resulted in super-Nernstian responses toward silver ions. Membrane electrodes prepared using a low dielectric constant plasticizer, however, exhibited sub-Nernstian responses. Polymer membrane electrodes with optimal composition (i.e., 2wt% DTBBT, 50mol% TFPB in FPNPE plasticized poly(vinyl chloride)) exhibited high potentiometric selectivity towards silver ions over alkali, alkaline earth, transition metal ions, as well as heavy metal ions such as Hg²⁺ and Pb²⁺. A good correlation was found between the potentiometric selectivity coefficients and the change in the UV-visible spectra of the ionophore upon exposure to different metal ions. The overall performance of the silver-selective membrane electrodes based on DTBBT ionophore, which is available at low cost, was found to be comparable to the performance of silver electrodes prepared with Fluka silver ionophore-IV. A DTBBT-based silver electrode was used as an indicator electrode for titrations of silver ions using standard sodium chloride solutions. Sharp inflections occur at the end point, and the data obtained showed 99.4% recovery with a standard deviation of 0.7% (n=3). In addition, the applicability of the DTBBT-based silver-selective electrode is illustrated by measuring the silver concentrations in natural water spiked with silver nitrate and by analyzing the silver in electroplating wastewater samples. The results obtained utilizing a DTBBT-based silver electrode showed very good agreement with the standard methods of analysis.     

Phase-selective a.c. adsorptive stripping voltammetry of lumazine on a hanging mercury drop electrode

The electrochemical behavior of lumazine (LMZ), an important antibacterial agent, has been studied at the hanging mercury drop electrode (HMDE). The nature of the process taking place at the HMDE was clarified. Its adsorption behavior at HMDE has been studied by using a.c and cyclic voltammetry (CV). Both the molecule and its reduced product appeared to be adsorbed at the surface of the electrode. Controlled adsorptive accumulation of LMZ on the HMDE provides the basis for the direct stripping measurement of that compound in the subnanomolar concentration level. Experimental and instrumental parameters for the quantitative determination were optimized. Phase-selective a.c voltammetry provided the best signal and gave a detection limit of 0.15 microg L(-1) (9.0 x 10(-10) mol/L) LMZ in aqueous solution. Molecules or ions which may interfere were studied.     

Complexes of chromium(III), manganese(II) and nickel(II) with methylhydrazinecarboxylate and 1,1-dimethylhydrazinecarboxylate ligands

Summary New complexes of chromium(III), manganese(II) and nickel(II) with methylhydrazinecarboxylate (MeCz) and of manganese(II) and nickel(II) with 1,1-dimethylhydra-zinecarboxylate (Me₂Cz) were prepared by reacting salts of the metals with CO₂-saturated solutions of the hydrazines in EtOH. The compounds [Cr(MeCz)₃]·2H₂O, Ni(MeCz)₂(H₂O)₃·MMH, Mn(MeCz)₂(H₂O)₂(MMH = monomethylhydrazine) and M(Me₂Cz)₂(H₂O)₂ (M = Mn or Ni) were investigated using d.t.a., t.g.a., electronic and i.r. spectroscopy and by magnetic susceptibility measurements.     

Intermolecular interactions in (arene)chromium carbonyl compounds: prediction of chiral crystal packing from racemate structure

Six X-ray crystal structures are reported, all containing substituted triphenylmethanol derivative 4 either alone or as its mono or bis(chromium tricarbonyl) complexes. All four chromium complexes studied crystallize with two independent molecules in the crystallographic asymmetric unit. It is demonstrated that from the X-ray crystal structure of the acentric racemic (+/-)-(1pR,1' 'R)(1pS,1' 'S)-[Cr(CO)(3)(eta(6)-t-BuC(6)H(3)(CMeOMe)CPh(2)OH)], (+/-)-3, it is possible to deduce the 4-fold helical structure of the chiral (-)-(1pR,1' 'R) isomer, (-)-3. The bimetallic derivatives demonstrate the ability to control intermolecular interactions by the positioning of relative stereochemistry.     

A convenient one-pot synthesis of substituted 2-pyrone derivatives

2-Pyrone derivatives were prepared in a one step procedure from readily available (chlorocarbonyl)phenyl ketene and 1,3-diketones such as 2,4-pentanedione, 1,3-diphenyl-1,3-propanedione, 1-phenyl-1,3-butanedione, 1,3-cyclohexanedione, 5,5-dimethyl-1,3-cyclohexanedione, 1,3-dimethyl-pyrimidine-2,4,6-trione and ethyl 2,4-dioxopentanoate. A mechanism is presented to account for the formation of the products. This method provides an easy route to prepare 3,4,5,6-tetrasubstituted 2-pyrones in good to excellent yields and in a short experimental time.     

Calculation of enthalpies of hydrogenation of hydrocarbons

Sets of hydrogen molecule equivalents have been developed which permit the calculation of hydrogenation of different types of carbon-carbon bonds from ab initio total energies (3-21G and 6-31G* basis sets, and, to a more limited extent, for MP2/6-31G* data) of reactants and products. The calculated enthalpies of hydrogenation are in good agreement with experiment for unstrained molecules, with average errors on the order of 2 kcal/mol. The 6-31G* equivalents allow the enthalpies for strained molecules to be calculated accurately, but the 3-21G equivalents do not. The equivalents for both basis sets have been tested by calculating the enthalpies of hydrogenation of carbon-carbon bonds in nitrogen- and oxygen-containing organic molecules, free radicals, and classical carbocations. The results are in good agreement with experiment in most cases.     

Synthesis of heterocycles. Part II. New routes to acetylthiadiazolines and alkylazothiazoles

Methylglyoxalyl chloride arylhydrazones (III) react with an ethanolic solution of thiourea to give 2-amino-4-methyl-5-arylazothiazoles (XII) instead of the expected 2-acetyl-4-aryl-5-imino-Δ²-1,3,4-thiadiazolines (V) which were obtained from III and potassium thiocyanate. 3-Thiocyanato-2,4-pentanedione (IV) coupled with diazotized anilines to give V. The postulated routes to formation of V and XII from III are given. Nitrosation of V gave the corresponding N-nitroso derivatives (VI) which decomposed upon refluxing in dry xylene to give 2,4-disubstituted-Δ²-1,3,4-thiadiazolin-5-ones (VII). Boiling of either V or VI with hydrochloric acid gave the hydrochloride salt (VIII). The thiadiazolines V gave the respective N-acyl derivatives (IX) and (X) with acetic anhydride and benzoyl chloride in pyridine.